|
|
|
| Ideal for motorhomes and towing applications |
|
|
The Traveler converter is intended for use in motorhomes, tow vehicles or other heavy duty applications where a slightly higher stall speed is helpful in getting the vehicle moving. The Traveler is also stronger than a stock converter and has been internally modified to provide about 300rpm more stall speed for help in initial acceleration without sacrificing normal highway operation. It is manufactured to B&M's exacting tolerances for long life.
* Ideal for motorhomes and towing applications. Provides slightly higher stall speed than stock to improve pulling power at low speeds.
* New Precision pump drive tube
* Heavy duty needle bearings
* Furnace brazed
* New sprag and rollers in stator
* Pressure tested
* Fully balanced
See the attached PDF for a list of transmissions matched to our Traveler torque converter applications.
Torque Converter Applications
 Traveler Torque Converter Application Information |
|
|
|
|
B&M Torque Converter Features
1. IMPELLER
Pumps fluid through converter and drives oil pump in transmission.
The impeller assembly is the a key area in the converter when considering the converters performance characteristics. The impeller can be modified to raise or lower the stall speed as well as affect the top end performance of the converter (MPH). By performing a fin bend change on the outside fins you can change the stall and change the top end MPH by a measurable amount.
2. FURNACE BRAZING
Furnace brazing (copper colored material visible on turbine fins) is a method used to strengthen converter components.
Braze material is applied to all of the fin areas, then the entire turbine is placed into a furnace, which heats up the braze material causing it to melt and fill the voids. Not only does this process strengthen the entire assembly it also makes the turbine more efficient by eliminating any of the cross leakage between the fins.
3. TURBINE
Spins input shaft in transmission.
The turbine assembly is completely furnace brazed. The turbine also includes a steel billet turbine hub with broached splines. This stronger turbine hub will eliminate the possibility of stripped splines in the center hub. The raised center section is designed to be a bearing and race pilot for the needle thrust bearing assembly.
4. STATOR
Multiplies torque by redirecting fluid flow in converter and incorporates one way clutch assembly
The stator has a very important function inside the converter as it multiplies torque by redirecting fluid flow in converter and it incorporates a one-way clutch assembly. The one-way clutch assembly allows the stator to hold, when the converter is multiplying torque and to spin in the direction of the oil flow when not holding.
5. COVER
Attaches converter to the flexplate
The cover assembly is essentially the stock cover with the addition of B & M designed drive lugs or modified stock drive lugs. The cover OD is machined to provide a smooth surface for the new body-weld. The pilot is inspected and re-machined as needed to provide a good fit into the crankshaft of the engine. This is extremely important as the pilot on the converter centers the converter behind the crankshaft. Proper alignment of the converter will eliminate most vibration problems related to the Converter and Transmission assembly.
|
   |
|
|
